52 Series Economy Offset Bracket Kits

We have recently released the "52" series of offset mounting hardware kits for not only the single axle fenders, but also the half, and full tandem fender systems. This new type of tube pairs the convenience of the offset tube design with the affordability of the existing straight tube kits. The Single Axle "52" [...]

2017-11-20T15:37:29+00:00 By |News|0 Comments

Poly Fender vs. A 12-gauge Shotgun

First off, we have to say that our fenders aren't bulletproof! So don't get any ideas here. We're always trying to think of new ways to put our materials and product designs to the test, even if we have to do something far out of the ordinary. We wondered, what would happen if we shot [...]

2017-03-21T14:36:31+00:00 By |News|0 Comments

Poly Fender vs. A Flying Cinder Block

We attempted to crush one of our SAF-225 fenders. That's a single axle poly fender with an almost 26" drop! It was about 15 degrees outside. The fender had been sitting out for about an hour before we shot the video. We were going to just throw the cinder block at it, but thought it [...]

2017-01-09T12:40:27+00:00 By |Featured, News|0 Comments

How to Find the Right Dumpster Lid

Finding the right type of dumpster lid is easy - but it can be a little bit tricky if you aren't familiar with dumpsters, or if you've never done it before. There's actually a wide variety of waste containers out there in the field. However, front and rear load containers are some of the most commonly used types. The first step in finding the lid you need is to [...]

2016-12-27T15:12:29+00:00 By |Featured, News|0 Comments